A juice groove is a shallow channel routed around the top face of a cutting board, about three quarters of an inch to an inch in from the edge. It catches juice from roasts, brisket, tomatoes, citrus and watermelon before it runs onto your counter. It is the most requested add-on we offer, and for good reason. Here is what a groove does, how we cut one and when you might skip it.
Five reasons to add a juice groove
- A cleaner counter. Carving a rested turkey or a rack of ribs releases a surprising amount of liquid. A groove holds it on the board.
- Better food safety. Raw meat juice that runs off the board spreads bacteria across the counter, onto towels and onto other food. Keeping it contained makes cleanup simpler and safer.
- You keep the good stuff. Those collected juices can go straight into a pan sauce or back over the sliced meat.
- Easier serving. A grooved board can go from carving to the table, which is why grooves are standard on our BBQ boards.
- A finished look. A clean, even groove frames the board and signals careful work.
How we cut a juice groove
We plan the groove around the size of the board and any handles, then mark it with a template so it sits the same distance from the edge all the way around. The channel is routed with a core box bit, which leaves a smooth, rounded U shape that is easy to wipe clean, unlike a sharp V shaped cut that traps food. We take it in more than one light pass for a clean surface, then sand the groove by hand through the same grits as the rest of the board and oil it so it sheds liquid just like the face.
An uneven groove is one of the most visible flaws a board can have, so this is a step we never rush. You can see more of our process in why a custom board takes time to build properly.
When a groove makes sense, and when it doesn’t
Add one if you carve meat, slice juicy fruit or use your board for serving and charcuterie. A groove on one face and a flat surface on the other gives you both options.
Skip it if the board is mostly for chopping vegetables, kneading dough or rolling out pastry, since you lose a little flat working area around the edge. Small boards under about 10 inches also have little room to spare. On end grain butcher blocks, a groove works well but is cut a little deeper because the surface is so absorbent.
Caring for a grooved board
- Scrub the groove with a soft brush when you wash the board so nothing dries in the channel.
- Dry it with a towel and stand the board on edge.
- When you oil the board, work oil or board butter into the groove too.
Pair it with other add-ons
Juice grooves pair well with routed handles for lifting a heavy board, rubber or premium feet to keep it from sliding, and engraving for gifts. See all the options in cutting board add-ons we offer, or add a groove to any size when you request a custom board.







